TradesPro 837254 Návod k použití a péči stáhnout pdf

MAINTENANCE

Disconnect air compressor from power source and bleed

off all air pressure before attempting any maintenance or repair

SHUTDOWN AND STORAGE:

NEVER stop the air compressor by unplugging it from the

power outlet as this may result in damage to the compressor.

1. Turn the switch to the OFF position

2. Disconnect the power cord from the power outlet. Disconnect the power cord

from the power outlet by grabbing the plug (not the cord). Loop around electric

cord holder for storage.

3. Turn the pressure regulator knob fully counterclockwise to close airflow from

air outlet port. Check the outlet pressure gauge to ensure that it reads 0 PSI.

4. Remove the air hose and any air accessories.

5. Drain moisture from the air tank by slowly opening the air tank drain valve by

turning counter clockwise. Tilt tank to remove all moisture. Once all the mois-

ture has drained out, close the fitting securely.

6. Allow the compressor to cool down.

7. Wipe the air compressor clean and store it in a clean, dry, and non-freezing location.

WHEN PERFORMING ANY MAINTENANCE OR SERVICE:

1. The air compressor must be turned off.

Disconnect compressor from the power source.

3. Open tank drain to bleed off all air pressure before attempting any maintenance

or repair.

4. Allow compressor to fully cool before attempting any maintenance or repair.

Check the air compressor frequently for any visible problems and follow mainte-

nance procedures each time the compressor is used.

MAINTENANCE CHECKLIST:

Daily:

• Drain accumulated liquid from tank.

• Check for unusual noise and/or vibrations.

• Check that all fasteners are secure.

• Wipe compressor clean.

1 2 3

PROBABLE CAUSE: SOLUTION: 2

Shrnutí obsahu

Strany 1

MAINTENANCE Disconnect air compressor from power source and bleedoff all air pressure before attempting any maintenance or repair.SHUTDOWN AND STORAGE

Strany 2 - PROBABLE CAUSE: SOLUTION:

Monthly:• Check for air leaks.MOISTURE IN COMPRESSED AIRMoisture is a normal by-product of compressing air. As the moisture builds duringcompressor us

Strany 3

Pressure regulator knob is Adjust pressure regulator knob to proper setting. not turned to high enough pressure.Defective motor ON/OFF Replace.switch